@jankocvara is the third picture the original headphone jack? I that the one you want to connect? First you have to identify which wires the for the Left and the Right speaker and then the one for a mic. After that you connect it standard for a TRRS connector.
Tip is commonly Left speaker
Ring is Right speaker
Ring is ground
Sleeve is Mic in
[image|3378911]
+
+
To test your headphone jack for the corresponding wires, Use a multimeter and set it to ohm mode. If it has continuity mode, set it to that. Strip the insulation about a 1/4 of an inch (6mm) of each wire. Place one probe on the tip of the connector. With the other probe check each one of the wires. The one that shows continuity will be the Left speaker. Now do the rest of the wires as well. Just move the probe on the jack to the 1st Ring, test the wires....and so on. Write those colors down so you know which wire belongs where.
@jankocvara is the third picture the original headphone jack? I that the one you want to connect? First you have to identify which wires the for the Left and the Right speaker and then the one for a mic. After that you connect it standard for a TRRS connector.
Tip is commonly Left speaker
Ring is Right speaker
Ring is ground
Sleeve is Mic in
[image|3378911]
+
+
To test your headphone jack for the corresponding wires, Use a multimeter and set it to ohm mode. If it has continuity mode, set it to that. Strip the insulation about a 1/4 of an inch (6mm) of each wire. Place one probe on the tip of the connector. With the other probe check each one of the wires. The one that shows continuity will be the Left speaker. Now do the rest of the wires as well. Just move the probe on the jack to the 1st Ring, test the wires....and so on. Write those colors down so you know which wire belongs where.
@jankocvara is the third picture the original headphone jack? I that the one you want to connect? First you have to identify which wires the for the Left and the Right speaker and then the one for a mic. After that you connect it standard for a TRRS connector.
@jankocvara is the third picture the original headphone jack? I that the one you want to connect? First you have to identify which wires the for the Left and the Right speaker and then the one for a mic. After that you connect it standard for a TRRS connector.
Tip is commonly Left speaker
Ring is Right speaker
Ring is ground
Sleeve is Mic in