crwdns2933423:0crwdne2933423:0
crwdns2918538:0crwdne2918538:0

crwdns2934243:0crwdne2934243:0 Benoit M.

crwdns2947189:0crwdne2947189:0:

Whirlpool WDT750SAHV - Incomplete cycle and potential motor issue

crwdns2934249:0crwdne2934249:0:

+***Edit :*** The issue was resolved by deeply cleaning the circulation pump, which I had to dismantle. I also took the opportunity to clean the drainage pump and the turbidity sensor. Thank you for your help!
+
+
+
+---
+
+
+
Hi!
I am reaching out for some guidance on my Whirlpool dishwasher, model WDT750SAHV, which has been showing some inconsistent behavior lately. I have observed a few issues and conducted some preliminary diagnostics:
* Initially, I noticed that the detergent tablets were not dissolving completely, and there was some residual moisture inside. Currently, only the 1hr wash cycle seems to function properly.
* With standard programs (e.g., Normal), I hear the drain engage, water enter, and then a long period of silence. It seems like the dishwasher thinks it's washing because I eventually hear the soap dispenser open. However, there are extended periods of silence, intermittent sounds of water, and at the end, some dishes are still slightly wet.
* I managed to run the diagnostic mode, which returned error 4-3. While I couldn't find the tech sheet for my specific model, a similar model's tech sheet (WDT790SAYM) suggests this might indicate an issue with the wash motor (not running). This is puzzling because the 1hr wash program appears to operate normally.
* During diagnostics, I hear a sound that seems to indicate the motor is trying to start but might be obstructed.
* I have cleaned the turbidity sensor, filters, and checked for any obstructions.
* The heating element seems to function as it gets very hot during drying (sometimes).
* I plan to repair it myself and have considered ordering the "Pump and Motor Assembly W11087376" but the part is quite expensive, and I want to exhaust all other possibilities first.
* There was an incident of water leaking from the door during a cycle, which I promptly stopped. I'm concerned about whether this could have affected the electrical components, although issues with the dishwasher existed before this incident.
Given these observations, I would greatly appreciate any advice or suggestions on further troubleshooting steps before proceeding with purchasing new parts. Could there be an underlying issue I might be overlooking?
Thank you for your time and assistance!
[image|3200376]
[image|3200377]
-
-
''To see all photos :''
[link|https://photos.app.goo.gl/MxjafLZSrfs5c35G6|https://photos.app.goo.gl/MxjafLZSrfs5c35G6|new_window=true]

crwdns2866306:0crwdne2866306:0:

WDT750SAHV

crwdns2915684:0crwdne2915684:0:

open

crwdns2934245:0crwdne2934245:0 Benoit M.

crwdns2947189:0crwdne2947189:0:

Whirlpool WDT750SAHV - Incomplete cycle and potential motor issue

crwdns2934249:0crwdne2934249:0:

Hi!
I am reaching out for some guidance on my Whirlpool dishwasher, model WDT750SAHV, which has been showing some inconsistent behavior lately. I have observed a few issues and conducted some preliminary diagnostics:
* Initially, I noticed that the detergent tablets were not dissolving completely, and there was some residual moisture inside. Currently, only the 1hr wash cycle seems to function properly.
* With standard programs (e.g., Normal), I hear the drain engage, water enter, and then a long period of silence. It seems like the dishwasher thinks it's washing because I eventually hear the soap dispenser open. However, there are extended periods of silence, intermittent sounds of water, and at the end, some dishes are still slightly wet.
* I managed to run the diagnostic mode, which returned error 4-3. While I couldn't find the tech sheet for my specific model, a similar model's tech sheet (WDT790SAYM) suggests this might indicate an issue with the wash motor (not running). This is puzzling because the 1hr wash program appears to operate normally.
* During diagnostics, I hear a sound that seems to indicate the motor is trying to start but might be obstructed.
* I have cleaned the turbidity sensor, filters, and checked for any obstructions.
* The heating element seems to function as it gets very hot during drying (sometimes).
* I plan to repair it myself and have considered ordering the "Pump and Motor Assembly W11087376" but the part is quite expensive, and I want to exhaust all other possibilities first.
* There was an incident of water leaking from the door during a cycle, which I promptly stopped. I'm concerned about whether this could have affected the electrical components, although issues with the dishwasher existed before this incident.
Given these observations, I would greatly appreciate any advice or suggestions on further troubleshooting steps before proceeding with purchasing new parts. Could there be an underlying issue I might be overlooking?
Thank you for your time and assistance!
+[image|3200376]
+
+[image|3200377]
+
+
+
+''To see all photos :''
+
[link|https://photos.app.goo.gl/MxjafLZSrfs5c35G6|https://photos.app.goo.gl/MxjafLZSrfs5c35G6|new_window=true]

crwdns2866306:0crwdne2866306:0:

WDT750SAHV

crwdns2915684:0crwdne2915684:0:

open

crwdns2934245:0crwdne2934245:0 Benoit M.

crwdns2947189:0crwdne2947189:0:

Whirlpool WDT750SAHV - Incomplete cycle and potential motor issue

crwdns2934249:0crwdne2934249:0:

Hi!
I am reaching out for some guidance on my Whirlpool dishwasher, model WDT750SAHV, which has been showing some inconsistent behavior lately. I have observed a few issues and conducted some preliminary diagnostics:
* Initially, I noticed that the detergent tablets were not dissolving completely, and there was some residual moisture inside. Currently, only the 1hr wash cycle seems to function properly.
* With standard programs (e.g., Normal), I hear the drain engage, water enter, and then a long period of silence. It seems like the dishwasher thinks it's washing because I eventually hear the soap dispenser open. However, there are extended periods of silence, intermittent sounds of water, and at the end, some dishes are still slightly wet.
* I managed to run the diagnostic mode, which returned error 4-3. While I couldn't find the tech sheet for my specific model, a similar model's tech sheet (WDT790SAYM) suggests this might indicate an issue with the wash motor (not running). This is puzzling because the 1hr wash program appears to operate normally.
* During diagnostics, I hear a sound that seems to indicate the motor is trying to start but might be obstructed.
* I have cleaned the turbidity sensor, filters, and checked for any obstructions.
* The heating element seems to function as it gets very hot during drying (sometimes).
* I plan to repair it myself and have considered ordering the "Pump and Motor Assembly W11087376" but the part is quite expensive, and I want to exhaust all other possibilities first.
* There was an incident of water leaking from the door during a cycle, which I promptly stopped. I'm concerned about whether this could have affected the electrical components, although issues with the dishwasher existed before this incident.
-
Given these observations, I would greatly appreciate any advice or suggestions on further troubleshooting steps before proceeding with purchasing new parts. Could there be an underlying issue I might be overlooking?
Thank you for your time and assistance!
+
+[link|https://photos.app.goo.gl/MxjafLZSrfs5c35G6|https://photos.app.goo.gl/MxjafLZSrfs5c35G6|new_window=true]

crwdns2866306:0crwdne2866306:0:

WDT750SAHV

crwdns2915684:0crwdne2915684:0:

open

crwdns2934241:0crwdne2934241:0 Benoit M.

crwdns2947189:0crwdne2947189:0:

Whirlpool WDT750SAHV - Incomplete cycle and potential motor issue

crwdns2934249:0crwdne2934249:0:

Hi!

I am reaching out for some guidance on my Whirlpool dishwasher, model WDT750SAHV, which has been showing some inconsistent behavior lately. I have observed a few issues and conducted some preliminary diagnostics:

* Initially, I noticed that the detergent tablets were not dissolving completely, and there was some residual moisture inside. Currently, only the 1hr wash cycle seems to function properly.
* With standard programs (e.g., Normal), I hear the drain engage, water enter, and then a long period of silence. It seems like the dishwasher thinks it's washing because I eventually hear the soap dispenser open. However, there are extended periods of silence, intermittent sounds of water, and at the end, some dishes are still slightly wet.
* I managed to run the diagnostic mode, which returned error 4-3. While I couldn't find the tech sheet for my specific model, a similar model's tech sheet (WDT790SAYM) suggests this might indicate an issue with the wash motor (not running). This is puzzling because the 1hr wash program appears to operate normally.
* During diagnostics, I hear a sound that seems to indicate the motor is trying to start but might be obstructed.
* I have cleaned the turbidity sensor, filters, and checked for any obstructions.
* The heating element seems to function as it gets very hot during drying (sometimes).
* I plan to repair it myself and have considered ordering the "Pump and Motor Assembly W11087376" but the part is quite expensive, and I want to exhaust all other possibilities first.
* There was an incident of water leaking from the door during a cycle, which I promptly stopped. I'm concerned about whether this could have affected the electrical components, although issues with the dishwasher existed before this incident.

Given these observations, I would greatly appreciate any advice or suggestions on further troubleshooting steps before proceeding with purchasing new parts. Could there be an underlying issue I might be overlooking?

Thank you for your time and assistance!

crwdns2866306:0crwdne2866306:0:

WDT750SAHV

crwdns2915684:0crwdne2915684:0:

open