@cav02 no you can't check the SMC that way. Let's see if find the schematic for your board and see which lines go where. Same with the PWM. Yes, use a multimeter and measure at the connector.
The 203W power supply was used on the Xenon/Zepher but that one was released in 2005. 2008 was JAsper
[image|3023072]
-
So if we identified your board correctly then this is the schematic for the fan control
+
If we identified your board correctly then this is the schematic for the fan control
@cav02 no you can't check the SMC that way. Let's see if find the schematic for your board and see which lines go where. Same with the PWM. Yes, use a multimeter and measure at the connector.
The 203W power supply was used on the Xenon/Zepher but that one was released in 2005. 2008 was JAsper
[image|3023072]
+
+
So if we identified your board correctly then this is the schematic for the fan control
@cav02 no you can't check the SMC that way. Let's see if find the schematic for your board and see which lines go where. Same with the PWM. Yes, use a multimeter and measure at the connector.
+
+
The 203W power supply was used on the Xenon/Zepher but that one was released in 2005. 2008 was JAsper
@cav02 no you can't check it that way unless we find the schematic for your board and see which lines go where. Same with the PWM. Yes, use a multimeter and measure at the connector.
+
@cav02 no you can't check the SMC that way. Let's see if find the schematic for your board and see which lines go where. Same with the PWM. Yes, use a multimeter and measure at the connector.
@cav02 no you can't check it that way unless we find the schematic for your board and see which lines go where. Same with the PWM. Yes, use a multimeter and measure at the connector.
[image|3023072]