Kitchenaid Dishwasher (KDTM404KPS0) will fill with water and "attempt" to progress with cycle...except, that the circulation never starts. All other functions seem to progress (soap door opens, intermittent fill and drain, etc).
Tried putting into diagnostic mode, all LEDs light up (any 3 buttons in succession 3 times). I then hit the second button and close the door and the diagnostic cycle starts. After a few minutes (about 4 and a half), the drain pump kicks on, drains the basin, and the diagnostic test stops. No flashing error codes.
Any ideas?
Kitchenaid Dishwasher (KDTM404KPS0) will fill with water and "attempt" to progress with cycle...except, that the circulation never starts. All other functions seem to progress (soap door opens, intermittent fill and drain, etc).
-
Tried putting into diagnostic mode, all LEDs light up (any 3 buttons in succession 3 times). I then hit the second button and close the door and the diagnostic cycle starts. After a few minutes, the diagnostic cycle just stops.
+
Tried putting into diagnostic mode, all LEDs light up (any 3 buttons in succession 3 times). I then hit the second button and close the door and the diagnostic cycle starts. After a few minutes (about 4 and a half), the drain pump kicks on, drains the basin, and the diagnostic test stops. No flashing error codes.
Kitchenaid Dishwasher (KDTM404KPS0) will fill with water and "attempt" to progress with cycle...except, that the circulation never starts. All other functions seem to progress (soap door opens, intermittent fill and drain, etc).
-
Tried putting into diagnostic mode, all LEDs light up (any 3 buttons in succession 3 times). I then close the door and nothing happens. After 5 minutes, the LEDs turn off (after not doing anything).
+
Tried putting into diagnostic mode, all LEDs light up (any 3 buttons in succession 3 times). I then hit the second button and close the door and the diagnostic cycle starts. After a few minutes, the diagnostic cycle just stops.
Kitchenaid Dishwasher (KDTM404KPS0) will fill with water and "attempt" to progress with cycle...except, that the circulation never starts. All other functions seem to progress (soap door opens, intermittent fill and drain, etc).
Tried putting into diagnostic mode, all LEDs light up (any 3 buttons in succession 3 times). I then close the door and nothing happens. After 5 minutes, the LEDs turn off (after not doing anything).
Any ideas?