***GE Spacemaker 2.0 JVM2070BH02.***
I was just heating a coffee cup of water to make tea. I always use 2 minutes and know that a few seconds more, it'll boil.
This time after 2 min .. water was cold. Tried again & the water was just warm. Add another 30 sec, got hot but no boil.
Ran it again later, 2.5 min .. almost boil.
It's set a power level 10 but seems like it lost some power (as if it was at 7 or 8).
It needs 25% more time to boil water.
New magnetron in 2018 when it had a loud hum & zero heat. The one-time pop this time is different.. is my magnetron starting to fail ? What else would make it act-up like this ?
Any insight would be appreciated.
Thanks, Ron