I was unable to find an equivalent drop in replacement using the part number that you supplied, but the following info may help.
-
As volume controls are usually a ''logarithmic'' type potentiometer, here is a [https://www.digikey.com/en/products/detail/precision-electronics-corporation/KKA1041S28/770961|2 gang 100K Ohm log pot] that may be suitable.
+
As volume controls are usually a ''logarithmic'' type potentiometer, here is a [link|https://www.digikey.com/en/products/detail/precision-electronics-corporation/KKA1041S28/770961|2 gang 100K Ohm log pot] that may be suitable.
-
Here is a [https://www.digikey.com/en/products/detail/bourns-inc/PDB182-K220K-104B/699765|2 gang 100K Ohm ''linear'' pot] if that is what is needed.
+
Here is a [link|https://www.digikey.com/en/products/detail/bourns-inc/PDB182-K220K-104B/699765|2 gang 100K Ohm ''linear'' pot] if that is what is needed.
-
In both cases, check the associated datasheet in the link to see if the dimension are are comparable to what you have now i.e. shaft length, diameter etc.
+
In both cases, check the associated datasheet in the link to see if the dimensions/ratings etc are comparable to what you have now i.e. shaft length, diameter etc.
-
Is there any information stamped on the potentiometer itself that may give further clues as to what type it is?
+
Is there any information stamped on the potentiometer itself that may give further clues as to what its specifications are?
Hi @vyengr
I was unable to find an equivalent drop in replacement using the part number that you supplied, but the following info may help.
As volume controls are usually a ''logarithmic'' type potentiometer, here is a [https://www.digikey.com/en/products/detail/precision-electronics-corporation/KKA1041S28/770961|2 gang 100K Ohm log pot] that may be suitable.
Here is a [https://www.digikey.com/en/products/detail/bourns-inc/PDB182-K220K-104B/699765|2 gang 100K Ohm ''linear'' pot] if that is what is needed.
In both cases, check the associated datasheet in the link to see if the dimension are are comparable to what you have now i.e. shaft length, diameter etc.
Is there any information stamped on the potentiometer itself that may give further clues as to what type it is?