Troubleshooting power ok, possible backlight but no picture
crwdns2934249:0crwdne2934249:0:
Hi, my 2711 almost toppled over today (was putting on a stand) but I caught it. Didn’t think anything of it until I noticed I was getting no picture. If I power cycle, no input cables attached, I don’t get the Dell boot up logo or any of the “no source” messages you’d expect. It’s just black, blue LEDs light and function, and I /think/ the screen is glowing a bit. Hard to tell in a well lit office. I was thinking of taking the back off and looking for a solder crack or similar, and maybe getting some replacement parts. I know it’s only worth $100 these days but it’s a fun project. Is there anyway to troubleshoot if it’s the boards before I buy some. What else could it be? Thanks!
+
+
UPDATE 2022-03-31
+
+
Pic of what I re-seated to make it work again! Thanks all!
Troubleshooting power ok, possible backlight but no picture
crwdns2934249:0crwdne2934249:0:
Hi, my 2711 almost toppled over today (was putting on a stand) but I caught it. Didn’t think anything of it until I noticed I was getting no picture. If I power cycle, no input cables attached, I don’t get the Dell boot up logo or any of the “no source” messages you’d expect. It’s just black, blue LEDs light and function, and I /think/ the screen is glowing a bit. Hard to tell in a well lit office. I was thinking of taking the back off and looking for a solder crack or similar, and maybe getting some replacement parts. I know it’s only worth $100 these days but it’s a fun project. Is there anyway to troubleshoot if it’s the boards before I buy some. What else could it be? Thanks!
Troubleshooting power ok, possible backlight but no picture
crwdns2934249:0crwdne2934249:0:
Hi, my 2711 almost toppled over today (was putting on a stand) but I caught it. Didn’t think anything of it until I noticed I was getting no picture. If I power cycle, no input cables attached, I don’t get the Dell boot up logo or any of the “no source” messages you’d expect. It’s just black, blue LEDs light and function, and I /think/ the screen is glowing a bit. Hard to tell in a well lit office. I was thinking of taking the back off and looking for a solder crack or similar, and maybe getting some replacement parts. I know it’s only worth $100 these days but it’s a fun project. Is there anyway to troubleshoot if it’s the boards before I buy some. What else could it be? Thanks!