This board always causes an error while restoring (usually error 4015 but last time it was error 9).
Log:
``<Restore Device 0x7f8235cd1f70>: operation 80 progress 1``
``[12:09:55.6073] requested restore behavior: Erase``
``[12:09:55.6110] <Restore Device 0x7f8235cd1f70>: operation 80 progress 1``
``[12:09:55.6111] requested restore behavior: Erase``
``[12:09:58.6406] <Restore Device 0x7f8235cd1f70>: operation 18 progress 0``
``[12:09:58.8493] RestoreOS mode device disconnected``
``[12:09:58.8493] RestoreOS device removed before restored completed``
``[12:09:58.8498] recv(13, 4) failed: connection closed``
``[12:09:58.8498] unable to read message size: -1``
``[12:09:58.8499] Failed to receive message from device, might be connection problem with USB host.``
I attached a DCPS and it draw 120 mA while in recovery mode. While restoring the current jumped higher than 200mA (my MM is broken so I could not see how much it really was) and stayed this high after this error occurred. I don’t think it’s normal behaviour.
What lines can I check that would produce this?