I need to replace the [https://www.ereplacementparts.com/micro-switch-p-629273.html|security microswitch SP0011048] in my 800CPXL, and I’m not sure how to remove the plastic shaft cap that supports the die cast reamer. I was able to determine the switch was broken without removing the cap (and everything sitting half way inside), but clean removal of the old part & soldering of the new part would be so much easier if I could pull everything out of the housing… [https://www.ereplacementparts.com/micro-switch-p-629273.html#RepairInstructions|Replacement instructions] where I bought the part simply say “disassemble the juicer”, and I think the cap is just pressure fitted on top of the shaft, but it’s not budging when trying to pull or pry it off & I don’t want to break it.