crwdns2933423:0crwdne2933423:0
crwdns2918538:0crwdne2918538:0

crwdns2934243:0crwdne2934243:0 Steve

crwdns2934249:0crwdne2934249:0:

My device was not charging, got a new device from Anker 3 days later. I disassembled the broken device. There are 2x16850 batteries in parallel (1S2P config) and a small protection PCB between them with blue shrink tube all around the pack. I replaced the protection PCB with a new one (8205a type, 5A) and it worked again. Unfortunately, could not fit it back into the small case again, so built a new one from nylon slats and gaffer tape^^
-[image|1674449][image|1674453]
+[image|1674449]
+
+[image|1674453]
+
+[image|1674451]

crwdns2915684:0crwdne2915684:0:

open

crwdns2934245:0crwdne2934245:0 Steve

crwdns2934249:0crwdne2934249:0:

My device was not charging, got a new device from Anker 3 days later. I disassembled the broken device. There are 2x16850 batteries in parallel (1S2P config) and a small protection PCB between them with blue shrink tube all around the pack. I replaced the protection PCB with a new one (8205a type, 5A) and it worked again. Unfortunately, could not fit it back into the small case again, so built a new one from nylon slats and gaffer tape^^
+
+[image|1674449][image|1674453]

crwdns2915684:0crwdne2915684:0:

open

crwdns2934245:0crwdne2934245:0 Steve

crwdns2934249:0crwdne2934249:0:

-My device was not charging, got a new device from Anker 3 daya later. I disassembled the broken device. There are 2x16850 batteries in parallel (1S2P config) and a small protection PCB between them with blue shrink tube all around the pack. I replaced the protection PCB with a new one (8205a type, 5A) and it worked again. Unfortunately, could not fit it back into the small case again, so built a new one from nylon slats and gaffer tape^^
+My device was not charging, got a new device from Anker 3 days later. I disassembled the broken device. There are 2x16850 batteries in parallel (1S2P config) and a small protection PCB between them with blue shrink tube all around the pack. I replaced the protection PCB with a new one (8205a type, 5A) and it worked again. Unfortunately, could not fit it back into the small case again, so built a new one from nylon slats and gaffer tape^^

crwdns2915684:0crwdne2915684:0:

open

crwdns2934241:0crwdne2934241:0 Steve

crwdns2934249:0crwdne2934249:0:

My device was not charging, got a new device from Anker 3 daya later. I disassembled the broken device. There are 2x16850 batteries in parallel (1S2P config) and a small protection PCB between them with blue shrink tube all around the pack. I replaced the protection PCB with a new one (8205a type, 5A) and it worked again. Unfortunately, could not fit it back into the small case again, so built a new one from nylon slats and gaffer tape^^

crwdns2915684:0crwdne2915684:0:

open