crwdns2933423:0crwdne2933423:0
crwdns2918538:0crwdne2918538:0

crwdns2934243:0crwdne2934243:0 oldturkey03

crwdns2934249:0crwdne2934249:0:

@marshada "All the injectors are fed from a common fuel rail as part of the returnless fuel system. Fuel pressure is maintained at a constant 3.5 bar (52 lbf.in2) by '''a regulator that is integral with the fuel pump'''.
[image|1316841]
It's in the tank.
+
+Pump - fuel
+NOTE: The fuel pump and fuel gauge tank unit are integral parts of the fuel pump housing and cannot be renewed separately
+Remove
+1. Release fixings and remove battery cover.
+2. Disconnect battery earth lead.
+3. Models with third row seats: Remove RH third row seat.
+4. Remove right hand rear lower quarter trim casing.
+5. Models with third row seats: Remove 4 screws securing third row seat latch finishers to body and finishers.
+6. Release and remove screw cover from rear floor carpet finisher.
+[image|1316847]
+7. Remove 6 screws securing loadspace carpet finisher, remove finisher.
+8. Release carpet and tie aside.
+[image|1316848]
+9. Remove 6 screws securing fuel pump access panel to floor.
+10. Remove access panel.
+11. Clean fuel pump hose connections.
+12. Position absorbent cloth to absorb fuel spillage.
+13. Disconnect multiplug and fuel hose from fuel pump housing.
+CAUTION: Always fit plugs to open connections to prevent contamination.
+14. NAS models: Disconnect pressure sensor pipe from fuel pump housing.
+CAUTION: Always fit plugs to open connections to prevent contamination.
+[image|1316846]
+15. Use LRT-19-009 to remove locking ring from fuel pump housing.
+16. Remove fuel pump and discard sealing ring.
+
+Refit
+1. Clean fuel pump housing and mating face on fuel tank.
+2. Fit new seal to mating face on fuel tank.
+3. Fit fuel pump assembly to fuel tank and use LRT-19-009 to fit locking ring.
+4. Connect multiplug and fuel hose to fuel pump housing.
+5. NAS models: Connect pressure sensor pipe to fuel pump housing.
+6. Fit fuel pump access panel and secure with screws.
+7. Reposition carpet.
+8. Fit carpet finisher and secure with screws.
+9. Fit screw cover.
+10. Models with third row seats: Fit and secure
+third row seat latch finishers.
+11. Fit right hand rear lower quarter trim casing.
+12. Models with third row seats: Fit RH third row seat.
+13. Connect battery earth lead.
+14. Fit battery cover and secure with fixings

crwdns2915684:0crwdne2915684:0:

open

crwdns2934241:0crwdne2934241:0 oldturkey03

crwdns2934249:0crwdne2934249:0:

@marshada "All the injectors are fed from a common fuel rail as part of the returnless fuel system. Fuel pressure is maintained at a constant 3.5 bar (52 lbf.in2) by '''a regulator that is integral with the fuel pump'''.

[image|1316841]

It's in the tank.

crwdns2915684:0crwdne2915684:0:

open