crwdns2934241:0crwdne2934241:0 Alan Ross

crwdns2934249:0crwdne2934249:0:

I used a needle. First I bent the needle at right angle about 1cm above the sharp end using a plyers. Then cut the tip just before the bend, so you end up with a short needle with a small bend at the end which acts as a hook.

I inserted the needle bend side first in the slot where the small gap between the sim and the slot end is, and hooked out the sim.

crwdns2915684:0crwdne2915684:0:

open