crwdns2933423:0crwdne2933423:0
crwdns2918538:0crwdne2918538:0

crwdns2934241:0crwdne2934241:0 Al Ridley

crwdns2947189:0crwdne2947189:0:

Washer filled with water then stopped working

crwdns2934249:0crwdne2934249:0:

I have a Whirlpool washer/dryer combo in which the washer has stopped working. This happened earlier today. I checked and the dryer still runs. I have unplugged the unit from the wall for a minute and also opened/closed the lid multiple times within a few seconds and that hasn't reset it or anything. I am not sure where in the cycle the washer stopped because I didn't pay attention to the knob before trying to figure out what was wrong with it, but the washer is full of water. I bailed out about 1/3 of the water and tried to 'reset' the cycle to see if it would start to fill up with water again but it still did nothing.

I should probably note that I recently bought some new towels that seem to have shed quite a bit in the dryer (the lint screen was plum full) but I figured if the washer was trying to drain it would at least make some sort of noise.

Any help would be appreciated. I would really like to get this fixed rather than go through the process of buying a new setup.

crwdns2866306:0crwdne2866306:0:

Whirlpool Washing Machine

crwdns2915684:0crwdne2915684:0:

open