Jeremy Holmes , Check/verify that you have the correct size belt installed and if worn/stretched replace it, then make sure all the belt keepers/retainer guards/guides/pins are in place and not bent away from pulleys too far(allowing belt to jump off)1/8" gap is good.Ensure belt routing is correct,check for worn bent pulley's or excess debri around them, level the deck. Link and pic. below may help Good luck. I hope this helped you out, if so let me know by pressing the helpful button.
Jeremy Holmes , Check/verify that you have the correct size belt installed and if worn/stretched replace it, then make sure all the belt retainer guards/guides/pins are in place and not bent away from pulleys too far(allowing belt to jump off).Ensure belt routing is correct,check for worn bent pulley's or excess debri around them. I will try to post a couple pic's in a minute or two. Good luck. I hope this helped you out, if so let me know by pressing the helpful button.
-
+
Jeremy Holmes , Check/verify that you have the correct size belt installed and if worn/stretched replace it, then make sure all the belt keepers/retainer guards/guides/pins are in place and not bent away from pulleys too far(allowing belt to jump off)1/8" gap is good.Ensure belt routing is correct,check for worn bent pulley's or excess debri around them, level the deck. Link and pic. below may help Good luck. I hope this helped you out, if so let me know by pressing the helpful button.
Jeremy Holmes , Check/verify that you have the correct size belt installed and if worn/stretched replace it, then make sure all the belt retainer guards/guides/pins are in place and not bent away from pulleys too far(allowing belt to jump off). I will try to post a couple pic's in a minute or two. Good luck. I hope this helped you out, if so let me know by pressing the helpful button.
+
Jeremy Holmes , Check/verify that you have the correct size belt installed and if worn/stretched replace it, then make sure all the belt retainer guards/guides/pins are in place and not bent away from pulleys too far(allowing belt to jump off).Ensure belt routing is correct,check for worn bent pulley's or excess debri around them. I will try to post a couple pic's in a minute or two. Good luck. I hope this helped you out, if so let me know by pressing the helpful button.
Jeremy Holmes , Check/verify that you have the correct size belt installed and if worn/stretched replace it, then make sure all the belt retainer guards/guides/pins are in place and not bent away from pulleys too far(allowing belt to jump off). I will try to post a couple pic's in a minute or two. Good luck. I hope this helped you out, if so let me know by pressing the helpful button.