I think the card has male connectors and antenna cable looks like female but inside it is filled with some black plastic material (maybe left over from previous card). That's why I cannot connect them!
I think I will try the soldering. I did not know if this was possible with my equipment as I thought each antenna cable has two wires inside.
-
So in this case, i can just remove the connector and solder the cable directly to the card? Right?
+
So in this case, i can just remove the connector and solder the cable directly to the card? Right?
+
+
Does it make a difference if I solder it to the inner pin or to the "outside of the connector" on the board?
Ok, thanks
I think I will try the soldering. I did not know if this was possible with my equipment as I thought each antenna cable has two wires inside.
So in this case, i can just remove the connector and solder the cable directly to the card? Right?
What temperature would you use to solder that?
Thanks