albert enstin there is no separate resistor other than in the relay, but you already replaced that. Check to ensure that you have power to the fuel pump relay
+
albert enstin there is no separate resistor other than the one in the relay. Since you already replaced the relayI'd suggest you check to ensure that you have power to the fuel pump relay.
[image|743244]
[image|189690]
Fuel Pump Resistor and relay (Speed)
Inspection
1. Disconnect the fuel pump resistor and relay connector. Measure the resistance between terminals A and B by using an ohmmeter
Specification:0.38-0.42 ohm
2. If not as specified, replace the fuel pump resistor and relay (speed).
albert enstin there is no separate resistor other than in the relay, but you already replaced that. Check to ensure that you have power to the fuel pump relay
-
[image|743244]
-
[image|189690|align=center]
+
[image|743244]
+
+
[image|189690]
Fuel Pump Resistor and relay (Speed)
Inspection
1. Disconnect the fuel pump resistor and relay connector. Measure the resistance between terminals A and B by using an ohmmeter
Specification:0.38-0.42 ohm
2. If not as specified, replace the fuel pump resistor and relay (speed).
albert enstin there is no separate resistor other than in the relay, but you already replaced that. Check to ensure that you have power to the fuel pump relay
-
[image|743244]
+
+
[image|743244]
+
[image|189690|align=center]
+
+
Fuel Pump Resistor and relay (Speed)
+
+
Inspection
+
+
1. Disconnect the fuel pump resistor and relay connector. Measure the resistance between terminals A and B by using an ohmmeter
+
+
Specification:0.38-0.42 ohm
+
+
2. If not as specified, replace the fuel pump resistor and relay (speed).
albert enstin, there is no resistor mentioned anywhere (other than in the relay, but you already replaced that). Check to ensure that you have power to the fuel pump relay
-
+
albert enstin there is no separate resistor other than in the relay, but you already replaced that. Check to ensure that you have power to the fuel pump relay
albert enstin, there is no resistor mentioned anywhere. Check to ensure that you have power to the fuel pump relay
+
albert enstin, there is no resistor mentioned anywhere (other than in the relay, but you already replaced that). Check to ensure that you have power to the fuel pump relay