Remove the torque converter by applying a screwdriver blade to the groove in its periphery
[image|608623]
NOTE: Use care not to damage the gasket surface of the crankcase.
REmove the needle roller bearings. Check them for wear, damage or other defects.
[image|608624]
+
+
=== Update (03/12/2023) ===
+
@miltonhope Here is how to install the torque converter
+
+
[image|2889247]
+
+
Put the needle roller bearing on the stator shaft.
+
+
Install the torque converter in the following sequence:
+
+
# Engage the primary driven and drive gears together.
+
# Set the transmission in 1st or 2nd gear, then align teh splines of the main shaft with those of the torque converter turbine by rotating the rear wheel by hand.
+
# Engage the kick starter driver gear with the kick idle gear while operating the kick pedal slowly.
+
[image|2889245]
+
+
Place the gasket on the crankcase, then press the two dowel pins into their respective positions.
+
+
***Note:***
+
+
* Check that the torque converter check valve is installed.
+
* Clean all passages in the torque converter case in/with solvent before installation
+
Pour the specified amount of oil into the engine through the oil filter opening.
+
+
[image|2889246]
+
+
Let me know if this works for you. If not, I can probably get the complete manual for you.
Wayne, it goes something like this:"
Drain all oil from the engine
Remove the torque converter case
[image|608622]
Remove the torque converter by applying a screwdriver blade to the groove in its periphery
[image|608623]
NOTE: Use care not to damage the gasket surface of the crankcase.
REmove the needle roller bearings. Check them for wear, damage or other defects.
[image|608624]